Parts & Tools Parts & Tools
Mechanics Mechanics
Gear Guide Gear Guide
search

How to Add Coolant: Chrysler Sebring (2007-2010)

We are still working to obtain content for your car,
however the video above is believed to have similar characteristics as your car.

 
Video Description

Adding engine coolant (also known as antifreeze) to your 2007 Chrysler Sebring is pretty easy. Engine coolant circulates through your engine to keep it cool in the summer but won't freeze in the winter. Make sure to check your engine when it is cold for an accurate reading. The video above shows you where the coolant reservoir in your Sebring is located and how to add coolant. Be sure to check your owners manual to determine the correct type of fluid to add - for Chryslers, it will typically be in a section titled Fluid Capacities in the back of your manual. Mix the coolant with distilled water so that you have a combination of 50% coolant and 50% water. Some coolants will come premixed-that is, you don't need to add any water. These coolants will typically say 50/50 or pre-mixed on the front of the coolant bottle.

Removing the coolant reservoir cap on a warm engine could cause the cap to fly off at a high rate of speed and fluid to spray out of the reservoir. Always wear safety goggles when working on your Sebring. Promptly wipe up any spilled fluid as it is highly toxic. Animals love its sweet taste, so even a spilling a small amount on your garage floor can end up in the dog's stomach pretty quickly. If you notice an oily surface in your coolant, immediately have your mechanic inspect your Sebring for head gasket leakage

Other videos you might find helpful

  • How to Clean Battery Corrosion: 2007-2010 Chrysler Sebring
    Clean the gunk off of your battery

    If your battery has green or white cruddy deposits, it is probably not getting enough juice from and will likely wear out sooner

    2007 Chrysler Sebring Limited 2.4L 4 Cyl.
  • Front Turn Signal Change Chrysler Sebring (2007-2010)
    Replace the front turn signal

    If your blinker doesn't blink, or blinks rapidly, you likely have a burnt out bulb

    2007 Chrysler Sebring Limited 2.4L 4 Cyl.
  • Reverse Light Replacement 2007-2010 Chrysler Sebring
    Replace reverse light

    White light when you back up - yup, they burn out and you can replace them with bright LEDs

    2007 Chrysler Sebring Limited 2.4L 4 Cyl.
  • How to Add Oil Chrysler Sebring (2007-2010)
    Top up the oil level

    Many cars will burn or leak a little bit of oil. Over time, this adds up and you might need to add some - learn how to here!

    2007 Chrysler Sebring Limited 2.4L 4 Cyl.
  • 2007-2010 Chrysler Sebring Brake Fluid Level Check
    Check your brake fluid

    Stop! Checking your brake fluid from time to time is a great way to ensure safe stopping

    2007 Chrysler Sebring Limited 2.4L 4 Cyl.
  • 2007-2010 Chrysler Sebring Hose Check
    Checking coolant hoses

    Coolant hoses wear out over time and need to be replaced - check 'em early and often

    2007 Chrysler Sebring Limited 2.4L 4 Cyl.
  • See all videos for the 2007 Chrysler Sebring
Comments
The Right Parts
The Right Tools
coolant drain pans stop leak safety glasses radiator hoses fluid pumps fuel injector cleaner gloves