Honda City helped make these videos
We are still working to obtain content for your car, however the video above is believed to have similar characteristics as your car.
The video above shows you how to change a burnt out front turn signal bulb on your 2008 Chevrolet Impala. If the turn signal (also known as a blinker or flasher) blinks rapidly or doesn't blink at all / stays stuck when engaged, this is your Impala's way of telling you that a turn signal bulb is burnt out. Troubleshooting for burnt out turn signal bulbs in your Impala is relatively easy - turn your hazard lights on and check the front of your Impala and then the back, whichever side is not illuminating is the side with the burnt out bulb. We recommend that you change both the driver and passenger side bulbs at the same time as they get dimmer over time and if one is out, then the other one is likely to burn out soon.
When changing the turn signal bulb in your Impala, be careful not to touch the glass portion of the bulb with your fingers as this will cause the bulb to burn out prematurely.
Your coolant should perform well under any condition - just like Aaron Rodgers!2008 Chevrolet Impala LT 3.5L V6 FlexFuel
Flushing the coolant in your car is not that hard and will extend the life of your engine tremendously - learn how here!2008 Chevrolet Impala LT 3.5L V6 FlexFuel
If your transmission is running low on fluid, be sure to add some - find out how to do this here!2008 Chevrolet Impala LT 3.5L V6 FlexFuel
Transmissions that leak fluid usually have never been flushed and the seal is finally leaking. The right stop leak product can cure a lot2008 Chevrolet Impala LT 3.5L V6 FlexFuel
Many cars will burn or leak a little bit of oil. Over time, this adds up and you might need to add some - learn how to here!2008 Chevrolet Impala LT 3.5L V6 FlexFuel
A few key tips will make jacking up your car much safer2008 Chevrolet Impala LT 3.5L V6 FlexFuel