We are still working to obtain content for your car, however the video above is believed to have similar characteristics as your car.
The video above shows you how to change a burnt out front turn signal bulb on your 2008 Chevrolet Uplander. If the turn signal (also known as a blinker or flasher) blinks rapidly or doesn't blink at all / stays stuck when engaged, this is your Uplander's way of telling you that a turn signal bulb is burnt out. Troubleshooting for burnt out turn signal bulbs in your Uplander is relatively easy - turn your hazard lights on and check the front of your Uplander and then the back, whichever side is not illuminating is the side with the burnt out bulb. We recommend that you change both the driver and passenger side bulbs at the same time as they get dimmer over time and if one is out, then the other one is likely to burn out soon.
When changing the turn signal bulb in your Uplander, be careful not to touch the glass portion of the bulb with your fingers as this will cause the bulb to burn out prematurely.
Flushing the coolant in your car is not that hard and will extend the life of your engine tremendously - learn how here!2008 Chevrolet Uplander LS 3.9L V6
Many cars will burn or leak a little bit of oil. Over time, this adds up and you might need to add some - learn how to here!2008 Chevrolet Uplander LS 3.9L V6
Don't send mixed signals - if your turn signal doesn't blink, or blinks rapidly, you likely have a burnt out bulb2008 Chevrolet Uplander LS 3.9L V6
Did you know that heat is worse for your battery than cold? Replace it every 4 years2008 Chevrolet Uplander LS 3.9L V6
White light when you back up - yup, they burn out and you can replace them with bright LEDs2008 Chevrolet Uplander LS 3.9L V6
Replacing a dirty air filter can improve gas mileage by up to 4%. Isn't efficiency great?2008 Chevrolet Uplander LS 3.9L V6