EN
Parts & Tools Parts & Tools
Mechanics Mechanics
Gear Guide Gear Guide
search

How to Clean Battery Corrosion: 2010-2012 Ford Fusion

We are still working to obtain content for your car, however the video above is believed to have similar characteristics as your car.

 
Video Description

If the battery in your 2010 Ford Fusion has crusty white or green build-up and corrosion on the clamps, posts or terminals, you can improve the performance and lifespan of your battery significantly by cleaning it. Your battery is depleted when it is used to start the car, but then recharged when you drive your Fusion, the corrosion limits the ability for your Fusion to recharge the battery when driving. The video above will show you the correct order to safely remove the battery clamps in your Fusion and what to use to clean your battery terminals and clamps. We will also show you a tip for preventing this buildup in the future so the battery in your Fusion will be optimally charged whenever you drive it!

Car batteries contain dangerous and flammable fluids. Always use safety glasses and gloves whenever working with the battery. Check out our parts page for great deals and coupons on safety glasses, gloves and battery terminal brushes for your Fusion!

Other videos you might find helpful

  • Add Windshield Washer Fluid Ford Fusion (2010-2012)
    Add washer fluid

    One of the easiest fluids to top off - learn how to open the hood and where the reservoir is on your car

    2010 Ford Fusion SE 2.5L 4 Cyl.
  • Check the Belts: 2010-2012 Ford Fusion
    Check the belts

    Unlike a waist belt, these usually become looser as they age! Learn how to check it here

    2010 Ford Fusion SE 2.5L 4 Cyl.
  • Coolant Level Check: 2010-2012 Fusion
    Be cool under pressure

    Your coolant should perform well under any condition - just like Aaron Rodgers!

    2010 Ford Fusion SE 2.5L 4 Cyl.
  • Blown Fuse Check 2010-2012 Ford Fusion
    Check for a blown engine fuse

    Odd electrical problems that come out of nowhere can often signify a blown engine fuse - check and change yours here!

    2010 Ford Fusion SE 2.5L 4 Cyl.
  • Rear Turn Signal Replacement Ford Fusion (2010-2012)
    Change a rear blinker

    Don't send mixed signals - if your turn signal doesn't blink, or blinks rapidly, you likely have a burnt out bulb

    2010 Ford Fusion SE 2.5L 4 Cyl.
  • Cabin Filter Replacement: Ford Fusion 2010-2012
    Change your cabin air filter!

    Dirty cabin air filter cause undue wear on your car's heater and AC and can cause bad odors

    2010 Ford Fusion SE 2.5L 4 Cyl.
  • See all videos for the 2010 Ford Fusion
Comments
The Right Parts
The Right Tools
batteries battery terminal cleaners terminal clamps battery chargers consoles and organizers preset protectors gps units safety glasses