1. Getting Started - Prepare for the repair
2. Open the Hood - How to pop the hood and prop it open
3. Access Battery - Learn where the battery is located
4. Remove Cables - How to disconnect the cables the right way
5. Clean Cables - Clean with baking soda, water and a wire brush
6. Connect Cables - Re-connect the cables in the right order
7. Replace Cover - Ensure the cover is put back properly
8. More Info. - Additional thoughts on corrosion prevention
If the battery in your 2010 Dodge Avenger has crusty white or green build-up and corrosion on the clamps, posts or terminals, you can improve the performance and lifespan of your battery significantly by cleaning it. Your battery is depleted when it is used to start the car, but then recharged when you drive your Avenger, the corrosion limits the ability for your Avenger to recharge the battery when driving. The video above will show you the correct order to safely remove the battery clamps in your Avenger and what to use to clean your battery terminals and clamps. We will also show you a tip for preventing this buildup in the future so the battery in your Avenger will be optimally charged whenever you drive it!
Car batteries contain dangerous and flammable fluids. Always use safety glasses and gloves whenever working with the battery. Check out our parts page for great deals and coupons on safety glasses, gloves and battery terminal brushes for your Avenger!
Hans Angermeier is an ASE certified Maintenance and Light Repair Technician and has produced over 100,000 videos showing drivers how to fix things on their cars. He has broad expertise on basic repair procedures covering the majority of cars on the road. Over the past 10 years, Hans has been focused on building CarCareKiosk, which is visited by millions of drivers each month.
On many cars, the high beam bulb runs at reduced power during the day - check 'em and change 'em!
If your brake fluid is a little low, learn how to add some here. Ignoring a low level leads to big problems
White light when you back up - yup, they burn out and you can replace them with bright LEDs
If your blinker doesn't blink, or blinks rapidly, you likely have a burnt out bulb