David Hobbs helped make these videos
We are still working to obtain content for your car, however the video above is believed to have similar characteristics as your car.
This video shows you how to replace a burnt out rear turn signal on your 2008 Chevrolet Impala. We recommend that you change both the driver and passenger side bulbs at the same time on your Impala as they get dimmer over time and if one is out, then the other one is likely to burn out soon. If the turn signal (also known as a blinker or flasher) blinks rapidly or doesn't blink at all or lights up without blinking when it is turned on, this is your Impala's way of telling you that the bulb is burnt out. Turn your hazard lights on and check the front of your Impala and then the back, whichever side is not lighting up is the side with the burnt out bulb.
When changing the turn signal bulb in your Impala, be careful not to touch the glass portion of the bulb with your fingers as this will cause the bulb to burn out prematurely.
Transmissions that leak fluid usually have never been flushed and the seal is finally leaking. The right stop leak product can cure a lot2008 Chevrolet Impala LT 3.5L V6 FlexFuel
Dirty cabin air filter cause undue wear on your car's heater and AC and can cause bad odors2008 Chevrolet Impala LT 3.5L V6 FlexFuel
Don't be the guy with your third brake light burnt out2013 Chevrolet Impala LT 3.6L V6 FlexFuel
Properly inflated tires is the easiest way to improve fuel economy. The right tire pressure is NOT on the side of your tire btw2013 Chevrolet Impala LT 3.6L V6 FlexFuel
Learn how to diagnose and fix minor oil leaks in your car2008 Chevrolet Impala LT 3.5L V6 FlexFuel
A/C blowing hot air?2013 Chevrolet Impala LT 3.6L V6 FlexFuel