Battery Replacement: 2008 Toyota Tacoma 2.7L 4 Cyl. Extended Cab Pickup (4 Door)

Toyota Tacoma Model Years - 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015

1. Getting Started - Prepare for the repair

2. Open the Hood - How to pop the hood and prop it open

3. Access Battery - Learn where the battery is located

4. Remove Bracket - Take off the bracket that secures the battery

5. Remove Cables - How to disconnect the cables the right way

6. Clean Cables - Clean with baking soda, water and a wire brush

7. New Battery - Install new battery and prevent corrosion

8. Secure Battery - Replace the bracket to secure the new battery

9. Replace Cover - Ensure the cover is put back properly

10. More Info. - Additional thoughts on replacing the battery

Author

Hans Angermeier is an ASE certified Maintenance and Light Repair Technician and has produced over 100,000 videos showing drivers how to fix things on their cars. He has broad expertise on basic repair procedures covering the majority of cars on the road. Over the past 10 years, Hans has been focused on building CarCareKiosk, which is visited by millions of drivers each month.

Share on   Share on Twitter   Share on Facebook
Parts & Tools
We may earn a commission from qualifying purchases as an Amazon Associate
Video Description

Where is the battery located in a Toyota Tacoma?

The video above shows you how to replace the battery in your 2008 Toyota Tacoma. We recommend changing the battery in Toyotas every 4 years. Although some batteries last much longer, most batteries begin breaking down chemically after four years, so you could experience dimmer headlights and other negative effects before you have a dead battery in your Tacoma that you need to replace.

The battery location in a Toyota Tacoma can typically be found in the engine bay, but may be in the trunk, fender or inside of the vehicle. You may need to remove the air filter housing, a plastic engine cover or parts of the cowl to find the battery in your Tacoma. See exactly where the battery is located in your 2008 Toyota Tacoma.

Replacing the battery in your Tacoma involves removing the terminals. When you reconnect the terminals, your radio presets are likely to be cleared out. In some Tacomas, you may need to re-enter a security code to get your radio to work again. Check for this code in your owners manual - it will usually be either a sticker or small card in the booklet. If you can't find it, call Toyota and they will give you the code for free. In many Toyotas, the transmission "learns" how you drive over time and makes adjustments, so you may experience altered driving dynamics as your car re-learns your driving style after changing the battery.

  • Advance Auto coupon for
    20% off entire order: KIOSK20
2008 Toyota Tacoma 2.7L 4 Cyl. Extended Cab Pickup (4 Door) Transmission Fluid Check Fluid Level

Harsh downshifts? Slipping gears? You might be low on transmission fluid

2008 Toyota Tacoma 2.7L 4 Cyl. Extended Cab Pickup (4 Door) Lights Daytime Running Light (replace bulb)

DRLs are on more than your headlights. They burn out faster and should be replaced regularly

2008 Toyota Tacoma 2.7L 4 Cyl. Extended Cab Pickup (4 Door) Lights Turn Signal - Rear (replace bulb)

Don't send mixed signals - if your turn signal doesn't blink, or blinks rapidly, you likely have a burnt out bulb

2008 Toyota Tacoma 2.7L 4 Cyl. Extended Cab Pickup (4 Door) Lights Reverse Light (replace bulb)

White light when you back up - yup, they burn out and you can replace them with bright LEDs