1. Getting Started - Prepare for the repair
2. Open the Hood - How to pop the hood and prop it open
3. Remove Oil Cap - Take off the oil fill cap
4. Add Oil - Determine the correct oil type and add oil
5. Replace Cap - Put the oil fill cap back on the engine
6. More Info. - Additional information on adding oil
The video above shows you how to add oil to your 2008 Toyota Tacoma. Before adding oil to your Tacoma, make sure that your engine was cold and that your car was parked on a level surface when you checked the oil level otherwise you won't be able to tell if your Tacoma has a low oil level. For most Toyotas, if your oil level is at the minimum mark on your dipstick, you should add about a quart of oil. If you are unsure how much oil to add to your Tacoma, add a little bit at a time and check your dipstick frequently. This video shows you where the oil fill cap is located on your Tacoma and how to add oil. Adding too much oil to your Tacoma can be harmful, so it is easiest to add a little at a time.
If you add too much oil to your Tacoma, you will need to remove some by loosening the drain plug underneath your engine - check out our video on how to change your oil & oil filter to see how to remove the excess oil.
Hans Angermeier has produced over 100,000 videos showing drivers how to fix things on their cars. He has broad expertise on basic repair procedures covering the majority of cars on the road.
Harsh downshifts? Slipping gears? You might be low on transmission fluid
DRLs are on more than your headlights. They burn out faster and should be replaced regularly
Learn where your spare tire and jack are located before you need it on the side of the road
Did you know that heat is worse for your battery than cold? Replace it every 4 years