Braeger Chevy helped make these videos
We are still working to obtain content for your car, however the video above is believed to have similar characteristics as your car.
The video above shows you how to add oil to your 2010 Scion xB. Before adding oil to your xB, make sure that your engine was cold and that your car was parked on a level surface when you checked the oil level otherwise you won't be able to tell if your xB has a low oil level. For most Scions, if your oil level is at the minimum mark on your dipstick, you should add about a quart of oil. If you are unsure how much oil to add to your xB, add a little bit at a time and check your dipstick frequently. This video shows you where the oil fill cap is located on your xB and how to add oil. Adding too much oil to your xB can be harmful, so it is easiest to add a little at a time.
If you add too much oil to your xB, you will need to remove some by loosening the drain plug underneath your engine - check out our video on how to change your oil & oil filter to see how to remove the excess oil.
There's no reason to check the washer fluid level without adding some - see how to do it here!2010 Scion xB 2.4L 4 Cyl.
Transmissions that leak fluid usually have never been flushed and the seal is finally leaking. The right stop leak product can cure a lot2010 Scion xB 2.4L 4 Cyl.
Don't be caught in the fog with burnt out fog light bulbs2010 Scion xB 2.4L 4 Cyl.
Don't send mixed signals - if your turn signal doesn't blink, or blinks rapidly, you likely have a burnt out bulb2010 Scion xB 2.4L 4 Cyl.
A few key tips will make jacking up your car much safer2010 Scion xB 2.4L 4 Cyl.
Carmakers are hiding interior fuse boxes all over the place these days - see how to check your interior fuses here!2010 Scion xB 2.4L 4 Cyl.