Coolant Flush How-to: 2012 Chrysler 300 Limited 3.6L V6

Chrysler 300 Model Years - 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019

How to drain coolant and do a radiator flush

Author

Hans Angermeier is an ASE certified Maintenance and Light Repair Technician and has produced over 100,000 videos showing drivers how to fix things on their cars. He has broad expertise on basic repair procedures covering the majority of cars on the road. Over the past 10 years, Hans has been focused on building CarCareKiosk, which is visited by millions of drivers each month.

2012 Chrysler 300 Limited 3.6L V6 Windshield Washer Fluid Add Fluid

One of the easiest fluids to top off - learn how to open the hood and where the reservoir is on your car

2012 Chrysler 300 Limited 3.6L V6 Coolant (Antifreeze) Add Coolant

Low coolant levels is all to common - top yours up today

2012 Chrysler 300 Limited 3.6L V6 Lights Turn Signal - Rear (replace bulb)

Don't send mixed signals - if your turn signal doesn't blink, or blinks rapidly, you likely have a burnt out bulb

2012 Chrysler 300 Limited 3.6L V6 Check Engine Light Diagnose

A check engine light can be cleared with a simple fix or it could be a major problem - find out now!

Share on   Share on Twitter   Share on Facebook
Parts & Tools
We may earn a commission from qualifying purchases as an Amazon Associate
Video Description

Learn how to flush the coolant (antifreeze) in your 2012 Chrysler 300. Coolant / antifreeze circulates through 300 radiator and engine to maintain the proper temperature. Coolant / antifreeze also passes through the heater core under your cowl to provide heat to the cabin of your 300. In addition to preventing your car from overheating, coolant / antifreeze also helps lubricate the seals in the water pump and hoses. Start your coolant flush by draining the coolant / antifreeze that is in your reservoir, then drain the coolant that is in your radiator by opening the petcock or removing the lower radiator hose. This video shows where the radiator drain plug (petcock) is located on a 2012 Chrysler 300. Fill up the radiator with distilled water and run the engine. Turn off the engine and drain the water, fill up the radiator with antifreeze until you have a 50/50 coolant / distilled water mixture and burp the system.

Like the oil in your 300, coolant gets dirty over time and loses its ability to cool down your 3.6 liter engine. When you flush your coolant, which is antifreeze, on your 2012, you are draining out all of the old dirty coolant and preventing costly radiator and cooling system repair down the road. The video above shows you where the petcock on your radiator is located, how to flush the coolant / antifreeze and how to burp the system to get the air out of your 300.

Coolant is toxic and animals are attracted to the sweet taste of coolant (antifreeze). If you spill coolant when you flush your 300, be sure to put down cat litter to soak it up to discard it. Flushing the coolant on a regular basis removes gunk and mineral deposits from your engine, while prolonging the life of your heater core, thermostat, hoses and water pump.

  • Advance Auto coupon for
    20% off entire order: KIOSK20