Tire Pressure for 2013 Chrysler 200 Limited 3.6L V6 FlexFuel Sedan

Chrysler 200 Model Years - 2011, 2012, 2013, 2014

1. Getting Started - Prepare for the repair

2. Check Tire Pressure - Find the correct tire pressure for your vehicle

3. Adjust Tire Pressure - How to increase and decrease the tire pressure

4. More Info. - Additional information on tire pressure

Author

Hans Angermeier is an ASE certified Maintenance and Light Repair Technician and has produced over 100,000 videos showing drivers how to fix things on their cars. He has broad expertise on basic repair procedures covering the majority of cars on the road. Over the past 10 years, Hans has been focused on building CarCareKiosk, which is visited by millions of drivers each month.

Share on   Share on Twitter   Share on Facebook
Parts & Tools
We may earn a commission from qualifying purchases as an Amazon Associate
Video Description

Did you know that the most important thing you can do to care for your tires and improve your fuel economy is to maintain the proper air pressure? Checking the tire pressure in your 2013 Chrysler 200 is relatively easy and important to do on a regular basis. Open the driver side door on your 200 and look for a sticker that indicates what the tire pressure should be. Don't use the maximum pressure indicated on the sidewall of your tires. It is best to check the tire pressure on your 200 in the morning before the car has been used or when you have driven it for less than a mile. When you drive your 200, the air inside your tires warms up and expands, so to get an accurate reading, check the tire pressure when the car has not been driven recently.

Many vehicles are equipped with a TPMS sensor in each wheel to detect the tire pressure of each tire. TPMS means tire pressure monitoring system. If your 2013 Chrysler 200 has a tire pressure light that illuminates in the dashboard when you start your vehicle, it has TPMS sensors. The TPMS light should illuminate briefly when you start your car, but then turn off afterwards. If your tire pressure light keeps coming on or the tire pressure light is blinking or flashing, then you likely have low tire pressure in your tires. For most vehicles, inflate the tires to the proper pressure and drive your vehicle a few miles and the tire pressure light will reset and turn off. TPMS sensors have batteries in them and they are mounted inside of the tire. Eventually that battery will die and the tire pressure sensor will need to be replaced in order to get the Chrysler 200 tire pressure light off.

Underinflated tires decrease the gas mileage of your 200, wear out faster and make the vehicle harder to steer, whereas overinflated tires blow out more easily, wear out faster and can cause unsafe handling dynamics. For these reasons and more – keeping your tires properly inflated on a regular basis is easy and important.

  • Advance Auto coupon for
    20% off entire order: KIOSK20
2013 Chrysler 200 Limited 3.6L V6 FlexFuel Sedan Transmission Fluid Check Fluid Level

Harsh downshifts? Slipping gears? You might be low on transmission fluid

2013 Chrysler 200 Limited 3.6L V6 FlexFuel Sedan Windshield Washer Fluid Check Fluid Level

There's no reason to check the washer fluid level without adding some - see how to do it here!

2013 Chrysler 200 Limited 3.6L V6 FlexFuel Sedan Air Filter (Cabin) Replace

Dirty cabin air filter cause undue wear on your car's heater and AC and can cause bad odors

2013 Chrysler 200 Limited 3.6L V6 FlexFuel Sedan Fuse (Engine) Replace

If you have an electrical component that doesn't work, try replacing the fuse first